Table of Contents
Advertisement
2.2
Parent unit battery Installation
Black
1.
Turn the belt clip so that it is in the hanging position.
2.
Loosen the screw in a counterclockwise direction using a small
screwdriver. Remove the battery cover.
3.
Insert the wire tab of the rechargeable battery pack into the contact
slot as shown above and fit the battery pack into the compartment.
4.
Close the battery compartment and tighten the screw in a
clockwise direction.
F
5.
Press
- It will take a few seconds to start up the unit.
6.
Press and hold
The battery icon
to be recharged. The battery pack takes about 15 hours to charge fully.
8
Red
to switch ON the parent unit. The LCD screen illuminates.
F
to switch OFF the parent unit.
indicates that the battery pack is low and needs
screw
Getting started
Advertisement
Table of Contents
