Table of Contents
Advertisement
REVERSING THE DOOR
Your Freezer has been built to open from the right; however, it has been
designed to open from either side and can easily be changed by following
the procedure below. You will need a screwdriver and putty knife or other
thin flat device to remove the hinge covers. Use care to prevent scratching
the surfaces.
1. Unplug the Freezer from the wall outlet and empty, including the shelves.
2. Remove the 2 top hinge covers and the screw-hole cover on the door and
set aside.
3. Place protective padding behind the Freezer. Turn the Freezer on its back
onto the protective padding.
4. Remove the screws from the current hinges.
5. Transfer the hinges into the receptacle on the other side of the door, and
thread and secure the screws in their new location. Replace the hinge
covers appropriately.
HOW TO USE
Setting the Temperature Control Dial
1. The Temperature Control Dial is located underneath the countertop
on the front side of the cabinet.
2. The first time you turn the unit on set the temperature control to
the maximum position, using the thermostat key provided. (If the key
is misplaced you may also use a coin or flathead screwdriver.)
3. The temperature range is from "1" the warmest, to "6" the coldest.
4. After 24 – 48 hours, adjust the temperature to suit your needs.
The setting of "4" should be appropriate for most needs.
5. To turn the Freezer off, turn the Temperature Control Dial to the "OFF"
position. NOTE: This only turns off the cooling cycle – not the power.
6. If the Freezer is unplugged, turned off, or without power for any reason,
DO NOT re-connect for at least five minutes to allow the circuits to reset.
Damage may occur if it is re-connected too soon.
7. The inside temperature of the Freezer will vary depending on the frequency
of the door opening and the amount of food.
5
Advertisement
Table of Contents
