GE GBE10ESJSB Owner's Manual And Installation Instructions page 7

Front Tabs
LED Assy.
Front
Snap
in
Tabs
Back
Light
Screw
Lens
Notch in
Light Lens
Replacing the LED Light
The LED light is located behind a light lens in
the celling of the refrigerator section.
To replace the LED light:
Remove the top shelf (if necessary).
Remove the Phillips screw at the back of
the light lens. Using your finger in the
notch at the back of the lens, pull the
light lens forward (toward the
refrigerator door) and down to release
the tabs at the back of the lens and then
away from the front of the refrigerator to
release the tabs at the front of the lens.
Slide the LED assembly from the
mounting slot.
Preparing for Vacation
For long vacations or absences, remove food
and unplug the refrigerator. Clean the interior
with a baking soda solution of one tablespoon
(15 ml) of baking soda to one quart (1 liter) of
water. Leave the doors open.
Preparing to Move
Remove food and unplug the refrigerator.
Secure all loose items such as shelves and
drawers by taping them securely in place to
prevent damage.
Gently pull the leads out and disconnect
from the unit.
Replace with new LED assembly and
slide assembly back into mounting slot.
Replace the light lens by sliding the tabs
at the front of the lens into the slots and
push up on the lens until the tabs at the
back of the lens snap into place. Secure
with the Phillips screw.
To order the LED assembly, please call
GE Appliances at 800.GE.CARES
(800.492.2737) during normal business
hours.
Be sure the refrigerator stays in an upright
position during moving.
GEAppliances.com
7