Advertisement
How to use
Remote control display
OFF / ON
TIMER/CLOCK
MODE
UP
SELECT
OFF/ON
DOWN
SET
CLOCK
CANCEL
Press and hold
for approximately
10 seconds to show
temperature setting
in °C or °F.
Not applicable
FAN SPEED
To select fan speed
(Remote control display)
• For AUTO, the indoor fan speed is automatically
adjusted according to the operation mode.
Information
Information for Users on Collection and Disposal of Old Equipment and used Batteries
Pb
6
FAN SPEED
MODE
QUIET/
TEMP
AIR SWING
POWERFUL
AC
RC
CHECK
RESET
Press to restore the
remote control to
previous setting.
Not used in normal
operations.
[Information on Disposal in other Countries outside the European Union]
These symbols are only valid in the European Union. If you wish to discard
these items, please contact your local authorities or dealer and ask for the
correct method of disposal.
Note for the battery symbol (bottom two symbol examples):
This symbol might be used in combination with a chemical symbol. In this case
it complies with the requirement set by the Directive for the chemical involved.
MODE
To select operation mode
AUTO - For your convenience
• Unit selects operation mode every 10 minutes
according to setting temperature and room
temperature.
HEAT - To enjoy warm air
• Unit takes a while to warm up.
COOL - To enjoy cool air
• Use curtains to screen off sunlight and outdoor
heat to reduce power consumption during COOL
mode.
DRY - To dehumidify the environment
• Unit operates at low fan speed to give a gentle
cooling operation.
To switch between
QUIET/
POWERFUL
quiet & powerful
QUIET
POWERFUL
QUIET: To enjoy quiet operation
• This operation reduces airflow noise.
POWERFUL: To reach temperature quickly
• This operation stops automatically after
Single
20 minutes.
• Press the button again or turn OFF the
Multi
unit to stop this operation.
Can be activated in all modes and can be
cancelled by pressing the respective button again.
Auto Restart Control
• If power is resumed after a power failure, the
operation will restart automatically after a period
of time with previous operation mode and airflow
direction.
• This control is not applicable when TIMER is set.
Single split system
Single
Multi split system
Multi
NORMAL
Advertisement
