Troubleshooting
Problem
Fabric softener
There is powdered
detergent left on
the laundry after
washing
There is an
unusual noise or
vibration
There is noise
when water drains
out
There is a fan
rotation sound.
There is a power
cut during
operation
The circuit breaker
trips during
operation
The water supply
is disrupted
The display is
unclear
32
(continued)
Cause and Measures
- The amount of softener used may have been above the
"MAX" line in the detergent drawer. (P. 12)
- The detergent drawer may have been closed too
strongly and spilt some of the softener.
- Powdered detergent may have been put directly into
the drum.
It should be put into the detergent drawer. (P. 12)
- There may be a metal item in the drum.
- The anchor bolts may not have been removed.
( P. 36)
- The appliance may be installed on a slope or an
unstable surface.
- Wet clothes may be loaded at the start of washing.
Perform spin process or wring out the laundry
beforehand.
- This is normal. It is the noise of the drain pump
working.
- This is normal. The fan cools electric parts.
- Operation will resume from the point it had stopped
when the power is recovered. (Auto restart)
- Figure out the cause and deal with it, then reset the
breaker.
Operation will resume from the point it had stopped
when the power is recovered. (Auto restart)
- After the water supply is restored, the water may be
discoloured for a short while.
Disconnect the water supply hose, run the tap until
the water is no longer discoloured, and reconnect the
water supply hose. (P. 38)
- The appliance may be in a brightly lit or sunlit area.