Table of Contents
Advertisement
Wireless-G Broadband Router
The Status Tab - Router
The Router screen on the Status Tab displays the Router's current status. The screen will vary depending on the
Internet Connection Type selected on the Setup screen.
Firmware Version. This is the Router's current firmware.
Current Time. The current time and date are displayed here.
MAC Address. This is the Router's MAC Address, as seen by your ISP.
Login Type. The status of the connection is displayed only for PPPoE, RAS, PPTP, or Heart Beat Signal
connections. For these dial-up style connections, there is a Connect button to click if there is no connection and
you want to establish an Internet connection, and a Disconnect button to disconnect the Internet connection.
Internet IP Address. The Router's Internet IP Address is displayed here.
Subnet Mask and Default Gateway. The Router's Subnet Mask and Default Gateway address are displayed
here for DHCP and static IP connections.
Figure 5-37: Status Tab - Router
DNS 1, 2, 3. Shown here are the DNS (Domain Name System) IP addresses currently used by the Router.
MTU. The current MTU settings, which were set on the Basic Setup screen, are displayed here.
DHCP Release. Available for a DHCP connection, click the DHCP Release button to release the current IP address
of the device connected to the Router's Internet port.
DHCP Renew. Available for a DHCP connection, click the DHCP Renew button to replace the current IP
address—of the device connected to the Router's Internet port—with a new IP address.
Chapter 6: Configuring the Wireless-G Broadband Router
33
The Status Tab - Router
Advertisement
Table of Contents
