LG RC7064A Owner's Manual page 7

I
nstallation Instructions
Washer Top plate size
21.7 inch
(550 mm)
Shape
and
assembly
direction
WARNING
• Incorrect installation can cause serious accidents.
• The weight of the dryer and the height of installa-
tion makes the stacking procedure too risky for
one person. This procedure should be performed
by 2 or more experienced service personnel.
• The dryer is not suitable for a built-in installation.
Please do not install as a built-in.
• Do not operate if the dryer is disassembled.
• When Placing the dryer, pull power cord out of a
power source.
• This dryer may only be stacked on top of an LG
washer. DO NOT attempt to stack this dryer on
any other washer, as damage, injury or property
damage could result.
1. Place the dryer on the Washing machine.
2. Remove the two screws from the bottom of the
rear cover on each side as illustrated below.
3. Align the stacking kit holes and the rear cover
holes.
23.6 inch
(600 mm)
3-1) 23.6 inch(600mm)
3-2) 21.7 inch(550 mm)
• Fasten the 2 screws that were removed earlier from
dryer to stacking kit.
• Use 4 screws in accessory box [0.6 inch (16mm)] to
assemble washer rear cover and stacking kit.
• The procedure for the opposite side will be the
same.
7