Table of Contents
Advertisement
WARNING:
r POWER
The wall outlet or circuit breaker (with rated current of 16 A or less) shall be installed near the
equipment and shall be easily accessible when problems occur. If the following problems occur, cut off
the power supply immediately.
Continued use of the projector in these conditions will result in fire, electric shock, or will cause visual
impairment.
f If foreign objects or water get inside the projector, cut off the power supply.
f If you notice smoke, strange smells or noise coming from the projector, cut off the power supply.
Please contact your dealer for repairs, and do not attempt to repair the projector yourself.
During a thunderstorm, do not touch the projector or the cable.
Electric shocks can result.
Do not do anything that might damage the power cord or the power plug.
If the power cord is used while damaged, electric shocks, short-circuits or fire will result.
f Do not damage the power cord, make any modifications to it, place it near any hot objects, bend it
excessively, twist it, pull it, place heavy objects on top of it or wrap it into a bundle.
Ask your dealer to carry out any repairs to the power cord that might be necessary.
Do not use a power cord other than the one supplied with the optional accessories.
Using the power cord other than the one supplied with the optional Mount Bracket and Floor Stand Kit may
cause shorting or overheating, result in electric shocks or fire. Also, using the power cord supplied with the
optional accessories without grounding at the outlet side may cause electric shocks.
Completely insert the power plug into the wall outlet and the power connector into the projector terminal.
If the plug is not inserted correctly, electric shocks or overheating will result.
f Do not use plugs which are damaged or wall outlets which are coming loose from the wall.
Do not handle the power plug and power connector with wet hands.
Failure to observe this will result in electric shocks.
Do not overload the wall outlet.
If the power supply is overloaded (ex., by using too many adapters), overheating may occur and fire will result.
Clean the power plug regularly to prevent it from becoming covered in dust.
Failure to observe this will cause a fire.
f If dust builds up on the power plug, the resulting humidity can damage the insulation.
f If not using the projector for an extended period of time, pull the power plug out from the wall outlet.
Pull the power plug out from the wall outlet and wipe it with a dry cloth regularly.
r ON USE/INSTALLATION
Ask your dealer or a building electrician for installing the projector to a wall or ceiling.
Inadequate installation may result in a fire, an electric shock, or a falling accident.
f Work of electrical wiring must be performed by qualified personnel only.
Use the installation kit (Mount Bracket) specified by Panasonic when the projector is used by installing
on a wall or ceiling.
Inadequate kit may result in a falling accident, a fire, or an electric shock.
Use the installation kit (Floor Stand Kit) specified by Panasonic when the projector is used standing on
the floor.
Inadequate stand may result in a tipping accident, a fire, or an electric shock.
Secure the safety of a foothold when directly accessing the main unit of the projector if the projector is
installed on a wall or ceiling.
You may tip over or fall down when adjusting the image position or inserting/removing the SD card, resulting in
an injury.
Make sure that the mounting work is carried out by two or more persons if the projector is installed on
a wall or ceiling.
Failure to observe this may result in damage or deformation of the projector, serious accidents or injury caused
by falling.
Do not install the projector on a wall or ceiling that cannot bear the weight.
Doing so may result in a fire or an electric shock due to falling of the projector.
6 - ENGLISH
Read this first!
Advertisement
Table of Contents
