On Setting Aspect (Image Angle); How To Change The Settings - Toshiba TDP-MT500 Owner's Manual

On setting ASPECT (Image angle)

This projector can change ASPECT ratio (The ratio between width and length of image frame) according
to input video signals.
16 : 9
Projects video Projects video
images at a
images on full
Original video
ratio of 4: 3.
screen (16: 9).
image
Picture images
with a ratio of 4: 3
(480i, 576i, 480p,
576p, and PC)
Cinemascope
and vista signals
with a ratio of 4: 3
Squeezed 4-to-
3 images
(480i, 576i,
480p, 576p)
16-to-9 images
(1080i)
16-to-9 images
(720p)
Bold frames are recommended modes.
* In zoom mode, it is possible to switch between display sizes (cinemascope/vista) with ZOOM button.
In cinemascope mode, it is possible to shift the display position with {, } buttons.

How to change the settings:

With the remote controller:
1. Press an ASPECT button (16: 9, 4 : 3, ZOOM, or DYNAMIC).
With the operation panel of the projector.
(Refer to Page 25 for the method of setting the menu.)
1. Reveal the signal setting menu.
2. Select "Image angle" by pressing {, } buttons.
3. Press ENTER button.
4. Select a desired image angle by pressing {, } buttons.
5. Press ENTER button.
When canceling the menu:
6. Press MENU button.
( ): name of remote controller button
DYNAMIC
4 : 3 ZOOM
Projects 4-to-3
Projects video
signals by
images of
expanding them
cinemascope
to 16-to-9 images
and vista size
on full screen
together with the
(Nonlinear).
caption.
Projected images
expand in
horizontal direction.
*or
VIEWING VIDEO IMAGES
REAL
Projects video
images of
input signals
as they are.
PC inputs not less
than SVGA are
projected on full
screen (16: 9).
Horizontal and
vertical size of the
projected images are
reduced to a half.
Projected images
are compressed to
the full screen size.
POWER ON/OFF
SOURCE
C1 C2
COMP1 COMP2
S V
S-VIDEO VIDEO
16:9 4:3
16:9 4:3
REAL
REAL
ASPECT
2
1
DISPLAY...
DVI
D
DVI-D
DVI
A
DVI-A
ZM
ASPECT button
ZOOM
DYN
DYNAMIC
3
ASPECT
16:9
4:3
ZOOM
DYNAMIC
REAL
23