Troubleshooting - HoMedics TOTAL CLEAN AP-DT10 Instruction Manual And Warranty Information

This product earned the ENERGY STAR by meeting strict energy efficiency guidelines set by the US EPA.
US EPA does not endorse any manufacturer claims of healthier indoor air from the use of this product.
The energy efficiency of this ENERGY STAR qualified model is measured based on a ratio between the
model's CADR for dust and the electrical energy it consumes, or CADR/Watt.

TROUBLESHOOTING

PROBLEM
Unit will not operate
Reduced airflow
Reduced odor removal
Excessive noise
Replace filter light remains lit
after filter replacement
POSSIBLE CAUSE
• Unit is not plugged in
• Power button not pressed
• No power to unit
• The back grille may be blocked
• Pre-filter needs vacuuming
• The filter needs to be replaced
• The filter needs to be replaced
• The unit is not level
• The replace filter indicator
needs to be reset
11
SOLUTION
• Plug unit in
• Press the power button to turn
the power on
• Check circuits, fuses, try a
different outlet
• Check to make sure nothing
is blocking the back grille and
air outlet
• Vacuum the pre-filter with
the brush attachment of your
vacuum cleaner
• Replace the filter
• Replace the filter
• Place the unit on a flat, level
surface
• Press and hold the ionizer
button for 3 seconds until the
replace filter light turns off