Sceptre X415 Manual page 48

Problems
WEAK SIGNAL OR
NO PROGRAM
SYMBOL ON
SCREEN
(OPTIONAL)
DISPLAY'S
UNIVERSAL
REMOTE CODE
TV CHANNELS ARE
BLOCKED
(OPTIONAL)
THE Display TURNS
ON OR OFF
SLOWLY AND THE
SCREEN SHOWS
UP SLOWLY
NO SOUND ON PC
HDCP VIDEO SAYS
NO HDCP SUPPORT
HDCP VIDEO HAS
NO AUDIO
CANNOT GET
1920x1080 ON PC
VGA
PICTURE IS
DISTORTED OR
HAS ABNORMAL
SOUND
PICTURE DOES
NOT COVER THE
ENTIRE SCREEN
(OPTIONAL)
The Display's tuner signal must not be lower than 65 %.Check
your signal.
The TV's tuner signal must not be lower than 65 %. Change the
direction of your antenna and rescan your channels. If you
have cable, call up your cable company and ask about signal
strength of your local cable.
This Display follows SONY's universal remote code. To find the
actual code you must read through your own universal remote's
guide book.
Check your auto lock function's settings inside the OSD. You
may have locked up some channels but forgot about them.
Refer to page 33 for more instructions.
This display is a High Definition liquid crystal display panel. It
requires a few more seconds than normal Displays to power up
and show the picture.
Make sure you have a 3.5 mm mini-jack cable connected from
your pc's sound output to the Display's VGA STEREO INPUT.
Reboot your HDCP video device but turning them off and
unplugging the power cord. Wait up to 8 minutes to plug the
power back in to see if it works or not.
Make sure you have a 3.5 mm mini-jack cable connected from
your HDCP video device's sound output to the Display's VGA
STEREO INPUT. If your HDCP video device uses RCA AUDIO
jacks, you'll need to obtain a RCA audio converted into 3.5 mm
mini-jack cable.
Make sure the Display is recognized as plug and play monitor.
Try updating your video card's drivers as well. If that does not
help, most likely you'll need to upgrade your video card to a
newer one.
This might be from interference from large electrical appliances,
cars, motorcycles, or fluorescent lights. If the Display is close
to the wall, try moving the Display to another room in your
house to see if the problem still occurs.
If you're using HDMI or a Display digital channel make sure you
use the ASPECT button to switch to 16:9 format. If you are
using VGA, use the AUTO ADJUST function to adjust to the
screen. Please Note : If you are using regular analog Display,
AV, or component in 480i resolution, use the ASPECT button to
switch to 16:9 in order to fill up the screen. Please Note : This
note this feature will distort the picture.
- 48 -
www.SCEPTRE.com
SCEPTRE X415 HD Display User Manual
Solutions