Lenovo ThinkPad T15v Gen 1 Hardware Maintenance Manual page 60

Table 10. System board connector and cable guide (continued)
Item
Connector (location)
6
EDP connector (internal)
7
DC-IN connector (external)
8
Thunderbolt 3 connector (USB-C)
(external)
9
Smart card reader connector
(internal)
10
M.2 solid-state drive connector
(internal)
11
Trackpad connector (internal)
12
Built-in battery connector
(internal)
13
Fingerprint reader connector
(internal)
14
Coin-cell battery connector
(internal)
15
Audio connector (external)
16
SD-card connector (external)
17
HDMI connector (external)
18
USB 3.2 connector Gen 1
(external)
19
Always On USB 3.2 connector
Gen 1 board connector (external)
20
Ethernet connector (external)
21
Nano-SIM-card slot (external)
22
Keyboard connectors (internal)
23
54
P15v Gen 1 and T15p Gen 1 Hardware Maintenance Manual
Internal cable required
EDP cable
DC-IN cable
No
Smart card reader cable
No
Trackpad cable
Built-in battery cable
Fingerprint reader cable
Coin-cell battery cable
No
No
No
No
No
Ethernet cable
No
Keyboard assembly cables
Cable connection
Connect one end of the EDP cable
to the LCD panel and the other end
to this connector.
Connect the DC-IN cable to this
connector.
Connect a USB-C compatible
device or a Thunderbolt 3
compatible device to this connector.
Connect one end of the cable to the
smart card reader and the other end
to this connector.
Insert the M.2 solid-state drive into
this slot.
Connect one end of the cable to the
trackpad and the other end to this
connector.
The built-in battery comes with a
cable. Connect the cable to this
connector.
Connect one end of the cable to the
fingerprint reader and the other end
to this connector.
The coin-cell battery comes with a
cable. Connect the cable to this
connector.
Connect headphones or a headset
with 3.5-mm (0.14-inch) 4-pole plug
to this connector.
Insert the SD card into this
connector.
Connect a compatible digital audio
device or video monitor to this
connector.
Connect USB-compatible devices to
this connector.
Connect USB-compatible devices to
this connector.
Connect one end of the Ethernet
cable to the Ethernet board and the
other end to this connector.
Install a nano-SIM card into the
nano-SIM card tray. Then, insert the
tray with the card into this slot.
The keyboard assembly comes with
the cables. Connect the cables to
these connectors.