Chapter 3 Installation Preparation; Hardware Description - Zte 831 User Manual

Chapter 3 Installation Preparation

3.1 Hardware Description

Front panel
Figure 3.1-1 Front Panel of the ZXDSL 831/831B/831II/831BII
Table 3.1-1 Descriptions of the LEDs on the Front Panel
LED No. Color Status
Off
Red Flash Software upgrade.
Power Green/Red
Green On Power on
Off
DSL Green
Flash
On
Off
Flash
Internet* Green
On
Off
Ethernet Green
Flash
On
Note*: The Internet LED is only effective for the ZXDSL 831/831II equipment
Power DSL Internet Ethernet
Note
Power off
No signals are detected
The MODEM is trying to be in the activation status
The MODEM has been activated.
The system is under the Bridge mode or the ADSL has
not been connected
There are some data packets passing the MODEM
The system is under the Route mode and the ADSL has
been connected. The MODEM IP data packet can be
normally transferred (For example, the built-in PPPOE
has been established and the dynamic IP address has
been obtained).
The Ethernet interface is in the non-communication
status
Data is received or sent on the Ethernet interface
The Ethernet interface is in the communication status
9