Table of Contents
Advertisement
After initial setup
1
M ake sure the TV is switched on.
2
K eep buttons
and
p ressed simultaneously for
5 seconds.
• T he green Setup light
lights up. The remote
control is now in setup
mode.
3
P ress and hold the button that does not function and
immediately release it when the TV responds.
• I f the button still does not function as expected, try
pressing it again for a longer period of time.
4
K eep buttons
and
pressed simultaneously for 5
seconds to save your settings
and exit setup mode.
•
W hen no button is
pressed for 5 minutes
or more, the remote control will exit setup mode,
automatically saving all your settings.
3 U sing the universal remote
control
3.1
Buttons and functions
The illustration on page 2 gives an overview of all buttons
on the remote control. Try out the buttons that you need
for operating your TV.
Notes
• B uttons having the same functions as the buttons
on your original remote control may have different
namings on the SRP1101.
• O nly functions that are available on your original
remote control can be used for operating your TV
with the SRP1101.
1
. .................................. s etup light. Lights up when a remote
control command is being sent and
when the remote control is in setup
mode.
................................. switches the TV on/off.
EN
6
5 sec.
5 sec.
Note
For some TV brands/types, the
off the TV. You will have to press a digit button (direct
channel selection) to switch on the TV again.
2
. ...................... t eletext on (
. ................................ s elects between regular (4:3) and
wide screen (16:9) TV.
................................ mutes TV sound.
3
. .................. p revious/next channel.
. .................. adjust TV volume.
4
.............. d igit buttons for direct channel/track
selection.
5
................................. s witches between external (Audio/
Video) inputs of your TV.
6
................................. s elects between one and two-figure
channel numbers and channel
numbers with more than two or
three figures.
3.2
R esetting a button to its original function
If an improved button (see chapter 2.2.1) still does not
function as expected, you can always reset the button to its
original function.
1
K eep buttons
and
pressed simultaneously for 5
seconds, until the green
Setup light lights up.
• T he remote control is
now in setup mode.
2
P ress digit buttons
,
and
, in that order.
• A fter each button press
the green Setup light
blinks once.
button will only switch
)/off (
).
5 sec.
EN
7
Advertisement
Table of Contents
