AEG LAVAMAT W 1020 Instruction Book page 26

Operating instructions
Malfunction
Excessive foaming
during the main wash.
Water runs out from
under the washing
machine.
Softener is not washed
in, compartment w
for conditioner is full
of water.
Appliance does not
spin, water in the
drum.
Washing is not spun
properly, water is still
visible in the drum.
It is not possible to
open the door.
Rinse water is cloudy.
26
Possible Cause
Probably too much detergent
was used
Threaded fitting on the
water inlet hose is leaking.
Drain hose is leaking.
Circulation pump cover is
not closed properly.
Washing is trapped in the
door.
Suction cap in the compart-
ment for conditioner is not
correctly positioned or is blo-
cked.
o (RINSE HOLD) selected.
Drain hose is kinked.
Maximum pumping height
(drain height 1m above the
floor on which the machine
is standing) exceeded.
Circulation pump is blocked.
In the case of siphon con-
nection: siphon is blocked.
The door is locked for safety
reasons.
This is probably due to using
a detergent with a high sili-
cate content.
Remedy
Dose detergent exactly in
accordance with the manu-
facturer's instructions.
Tighten the water inlet hose
Check drain hose and if
necessary replace.
Close cover properly.
Stop program, remove
washing from the door, start
a new program.
Clean detergent drawer,
place suction cap firmly in
position.
Deselect o (RINSE HOLD).
Remove kink.
Please contact customer ser-
vice who have a retrofit kit
for pumping to heights of
greater than 1m.
Switch off the machine and
unplug from the mains, clean
the circulation pump.
Clean siphon.
Wait 1-2 minutes after the
end of the program.
No negative impact on the
rinsing results, try using
liquid detergent.