Advertisement
Procedure 2A → 2B → 2C → 2D
Ref. No. 2D
Procedure 2A → 2B → 2C → 2D → 2E
Ref. No. 2E
Fig. 14
Fig. 16
Assembly of the Adjusting Screw and the Clutch Handle.
1. Hold the driving block with the click spring on top, and align the
smallest projection of adjusting screw with the clutch case. (See Fig.
14)
NOTE:
Make sure that the adjusting screw has its own correct direction
for proper assembly. Failure to do so, the clutch handle does not
rotate properly.
2. Turn the adjusting screw into the driving block about one rotation
for clockwise direction.
3. Set the clutch handle with position 1 on top. (See Fig .15)
Fig. 15
Assembly of the Switch.
1. Press fit the lead wires firmly and set the black lead wire on top.
NOTE:
Make sure that the parts of thermistor may not contact housing
rib.
9
Advertisement
