Related Manuals for Philips SDV8625T/27
Summary of Contents for Philips SDV8625T/27
- Page 1 Register your product and get support at www.philips.com/welcome SDV8625T/27 EN User manual...
-
Page 3: Table Of Contents
Safety For indoor use For outdoor use Notice for USA Notice for Canada Recycling 2 Your SDV8625T/27 What’s in your box 3 Get started Installation Connect to the TV Set up a digital tuner with this antenna 10 4 Frequently asked questions... -
Page 4: Important
1 Important Safety This manual contains important information about the Philips indoor/outdoor television antenna. Read it carefully before you start the installation and setup. For indoor use • The product shall not be exposed to dripping or splashing and no objects filled with liquid, such as vases, shall be placed on the product. -
Page 5: Notice For Canada
When this logo is attached to a product, it means a financial contribution has been paid to the associated national recovery and recycling system. © 2011 Koninklijke Philips Electronics N.V. All rights reserved. Reproduction in whole or in part is prohibited without the written consent of the copyright owner. Trademarks are the property of Koninklijke Philips Electronics N.V. -
Page 6: What's In Your Box
What’s in your box 9 10 a SDV8625T/27 antenna b Power supply 100-240V AC / 6V DC 500mA c Wall/Mast bracket d Nut e U-Bolts f Mast clamps g Nuts with lock washers h 25mm wood screws i 6m coax cable with connectors... -
Page 7: Get Started
3 Get started Installation Installation information This antenna uses a power inserter module to power the antenna amplifier. It is essential for proper operation of this antenna system that the power inserter be connected between the antenna and any devices such as splitters, matching transformers, networks, etc. - Page 8 For wood wall Use the wood screws to fix the antenna to the wood wall firmly. For concrete wall Drill four holes on concrete wall, put four plastic anchors into the holes. Use wood screws to fix the antenna to the concrete wall firmly. For outdoor mast mount installation • 3.2mm (1/8”) 27±5mm 1.1”±0.2” 7.9mm (5/16”) 35±5mm 1.4”±0.2” Note Complete all assembly work on the ground.
- Page 9 Attach the assembly to the mast firmly. Rotate the mast in its mount to adjust the direction. Attach the coaxial cable connector on the underside of the unit. Position the weather boot connection. Rotate You can make a 90 degree rotation to the antenna or the mounting post. to the F over the...
-
Page 10: Connect To The Tv
Connect to the TV Note • As previously noted, the amplifier (Power injector + Power supply) must be placed in- line between the antenna and any splitter or additional devices. Connect the coaxial cable antenna to the connector labeled ANT on the power injector . Connect the power injector antenna input on the TV, digital set-top box, splitter or other devices. -
Page 11: Frequently Asked Questions
1-919-573-7854. THERE ARE NO OTHER EXPRESS OR IMPLIED WARRANTIES. The liability of Philips is limited to repair or, at its sole option, replacement of the product. Incidental, special and consequential damages are disclaimed where permitted by law. This warranty gives you specific legal rights. -
Page 12: Glossary
6 Glossary Amplifier A device, either a single stage or a large scale circuit with multiple stages for creating gain, i.e. it makes small signals larger. Antenna A device, such as a rod or wire, which picks up a received radio frequency signal or radiates a transmitted RF signal. - Page 14 © 2011 Koninklijke Philips Electronics N.V. DFU_SDV8625T_27_V1.1 All rights reserved.