Advertisement
Problem
I cannot increase or
decrease the light intensity
settings/All intensity lights
are blinking alternately
The device produces a
strange smell.
The skin feels more
sensitive than usual during
treatment/ I experience an
unacceptable pain
sensation when I use the
device.
The skin reaction after
treatment lasts longer than
usual.
Possible cause
The device needs to be reset. To reset the device, switch it off and
The attachment or the filter
glass is dirty.
You have not removed the
hairs on the area to be
treated properly. These hairs
may get burned and can
cause the smell.
The light intensity setting you
use is too high.
You did not remove the hairs
on the areas to be treated.
The UV filter of the light exit
window is broken.
You treated an area for which
the device is not
intended.The appliance is not
suitable for skin colour
The device is not suitable for
your skin.
You have used a light
intensity setting which is too
high for you.
Solution
switch it on again.
Clean the attachment carefully.
Pretreat your skin before you use Lumea.
Check if you have selected the right light
intensity setting. If necessary, select a
lower setting.
Pretreat your skin before you use Lumea.
If the UV filter is broken, do not use the
device anymore. Contact the Consumer
Care Center in your country, your Philips
dealer or a Philips service center.
Never use the device on the following
areas:the face, inner labia, anus, nipples,
areolas, lips, inside the nostrils and ears,
around the eyes and near the eyebrows.
Men must not use it on the face, neck or
on the scrotum.
Do not use the device if you have skin
type VI or V, a brownish black or darker
skin tone.
Select a lower intensity next
time. See chapter 'Using your Philips
Lumea', section 'Selecting the right light
intensity'.
English
17
Advertisement
