System Settings - Pioneer MVH-X199UI Owner's Manual

Menu Item
SUB.W CTRL*2*3
Cut-off frequency: [50HZ],
[63HZ], [80HZ], [100HZ],
[125HZ], [160HZ], [200HZ]
Output level: [–24] to [+6]
Slope level: [–12], [–24]
BASS BOOST
[0] to [+6]
HPF SETTING
Cut-off frequency: [OFF],
[50HZ], [63HZ], [80HZ],
[100HZ], [125HZ], [160HZ],
[200HZ]
Slope level: [–12], [–24]
SLA
[+4] to [–4]
*1 Not available when [SUB.W/SUB.W] is selected in [SP-P/O MODE] in the INITIAL settings
(page 5).
*2 Not available when [REAR/REAR] is selected in [SP-P/O MODE] in the INITIAL settings
(page 5).
*3 Not available when [OFF] is selected in [SUB.W].

SYSTEM settings

You can also access to these menus when the unit is turned off.
Menu Item
CLOCK SET
12
En
Description
Only frequencies lower than those in the
selected range are output from the
subwoofer.
Select the bass boost level.
Only frequencies higher than the high-pass
filter (HPF) cutoff are output from the
speakers.
Adjust the volume level for each source
except FM.
Each of the below combinations are set to
the same setting automatically.
• USB, iPod, ANDROID, and APP (iPhone)
Description
Set the clock (page 5).
Menu Item
12H/24H
[12H], [24H]
AUTO PI
[ON], [OFF]
AUX
[ON], [OFF]
ANDROID WIRED
[MEMORY], [APP CONTROL]
P.APP AUTO ON
[ON], [OFF]
S.REMOTE*1*2
[OFF], [PIONEER], [PRESET]
USB AUTO
[ON], [OFF]
*1 Depending on your car, this function may not work properly. In this case, contact your
dealer or an authorized PIONEER Service Station.
*2 Please use a commercially available wiring harness for each car model when [PRESET]
mode is engaged, and use a commercially available adapter when in [PIONEER].
Description
Select the time notation.
Search for a different station with the same
programming, even if using a preset
station.
Set to [ON] when using an auxiliary device
connected to the unit.
Select the appropriate connection method
for an Android device.
Select [ON] to automatically launch Pioneer
ARC APP when an Android device is
connected to the unit via AOA. (Not available
when [MEMORY] is selected in [ANDROID
WIRED].)
Select [PIONEER] or [PRESET] according to
your wired remote control.
Select [ON] to automatically switch to
[USB] source when a USB device/iPod is
connected to the unit.
Select [OFF] when a USB device/iPod is
being connected to the unit just for
charging.