Dp Out (S24A60*U / S27A60*U / S32A60*U Model Only.); Dp Out (Mst/Sst) Function Implementation - Samsung S27A60 Series User Manual

DP OUT (S24A60*U / S27A60*U / S32A60*U
model only.)
Select the input signal to output to the next monitor and the output mode to simplify the connection
and control of displaying devices.
― If the
MST mode is selected for DP OUT, FreeSync
― Before selecting the
MST mode for DP OUT, make sure that the device supports
Chain)/HBR2 (High Bit Rate). Incorrect settings may lead to black screen or inconsistency between the
actual output mode and the selected output mode. If a black screen occurs, change the
mode.
― Two units can be connected for MST and four units can be connected for SST.
― Samsung S60* series monitor is recommended for SST connection.
• MST/SST: A technology used for connection and driving of multi-stream display signals.
‒ MST: Stands for Multi-Stream Transport. Can transport multiple video and audio streams, but
needs the support of both the drive capacity of the graphics card and the resolution of the
monitor.
‒ SST: Stands for Single Stream Transport. Can transport only a combination of a single video
stream and a single audio stream.
• DP OUT mode: 5 modes
USB Type-C:MST
USB Type-C:SST
DisplayPort:MST
DisplayPort:SST
HDMI:SST
is not supported for all connected monitors.
DisplayPort:MST
DP OUT

DP OUT (MST/SST) Function Implementation

Connecting a PC via DisplayPort
PC
(Daisy
MST
output
DP Cable
PC
SST
DP Cable
• Make sure that the graphics card supports the MST (Daisy Chain) function. To check this, visit the
website of the graphics card manufacturer.
• The output mode of
set to 1.1, DP OUT only supports SST.
• When connecting a PC using DP cable, you must set DP OUT mode to "DisplayPort: MST (SST)" on
the OSD menu. (OSD –
• Because of the bandwidth limit of DisplayPort Ver. 1.2, up to two 2560 x 1440 @ 75 Hz monitors
can be connected and used. But this specification may vary depending on the cable used and the
performance of the graphics card.
Monitor 1
Screen A
DP Cable
OSD → DisplayPort:MST
Monitor 1
Screen A
DP Cable
OSD → DisplayPort:SST
DP OUT varies with the settings of DisplayPort Ver. When
System – DP OUT - DisplayPort:MST/DisplayPort:SST)
Monitor 2
Screen B
Monitor 2
Screen A
DisplayPort Ver. is
22