Pentair ERIFLEX UD80A Instruction Sheet

INSTRUCTION SHEET
UD80A
NOTE:
1. Tighten screws of all unused galleries to the specified torque above.
569010
2. For multiple phase assemblies, join blocks together before installing on DIN Profile.
3. The input must be fixed or maintained at approximately 15cm from the block.
54.0mm
4.5mm
WARNING:
1. Pentair products shall be installed and used only as indicated in Pentair product instruction sheets and training materials. Instruction sheets are available at
www.erico.pentair.com and from your Pentair customer service representative.
2. Pentair products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
3. All instructions must be completely followed to ensure proper and safe installation and performance.
4. Improper installation, misuse, misapplication or other failure to completely follow Pentair's instructions and warnings may cause product malfunction, property
damage, serious bodily injury and/or death, and void your warranty.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
Pentair, CADDY, ERICO CADWELD, ERICO CRITEC, ERICO, ERIFLEX, and LENTON are owned by Pentair or its global affiliates. All other
trademarks are the property of their respective owners. Pentair reserves the right to change specifications without prior notice.
IEC is a registered trademark of International Electrotechnical Commission
M5
TECHNICAL SUPPORT
www.erico.pentair.com
IP7802_L 1 OF 2 © 2004-2016 Pentair All Rights
Reserved
I = 80A
Ui = 1000V AC/DC
Uimp = 12kV
Ipk = 22kA
Icw = 3kA rms @ 1 sec
Flat