Eureka Apex 2XT Setup Instructions

Eureka! Set-Up Instructions
Apex 2XT (#2629101)
Apex 3XT (#2629103)
Apex 4XT (#2629106)
ALWAYS SET UP YOUR TENT PRIOR TO FIRST USE TO
UNDERSTAND SET UP PROCEDURES!
Contents of Carry bag
Tent body
Fly sheet
Tent footprint
Accessory bag with tent stakes and guyout cords
Frame bag containing: complete frame system with central hub, 4
main frame sections, and 2 ridge poles
Setting up the Tent Body
1. Unpack the carry bag and identify all parts
2. Spread out the tent footprint
3. Spread out tent body (floor side down) on top of tent
footprint while locating the green stake out loop
4. Assemble the frame system
a. Attached the tent's central peak clip to the underside of
the frame hub
b. Insert green main frame end tip into grommet on green
stake out loop at floor corner
c. Insert adjacent main frame end tip into adjacent grom-
met at floor corner
d. At each opposite corner, apply pressure to flex the main
frame section and insert end tips (2) into grommets at
floor corners
e. Insert ridge pole frame end tips into grommets at front
and rear roof of tent
f. Attach all tent body clips to appropriate main frame and
ridge pole frame sections
Staking the Tent
1. Insert tent stake through matching green tent body and
tent footprint stake out loops and secure stake into ground
2. Locate stake out loops diagonally opposed to the green
stake out loops. Repeat step 1, while applying tension to
pull the tent floor taught
3. Repeat step 2 for the remaining stake out loops
Attaching the Fly Sheet
1. Drape fly sheet over the tent body while locating the
green webbing and side release buckle
2. Orient the fly sheet so that the green webbing and side
release buckle align with the corresponding green stake
out loop and green side release buckle on the tent body
3. Ensure that the fly sheet center seam aligns with the
ridge pole frame sections
4. Reach under the fly sheet and secure all hook+loop
attachment points to the frame sections
5. Attached all fly sheet side release buckles to corre-
sponding buckles on tent body
6. Stake down front and rear vestibules
7. Secure side pullout by inserting toggle (on fly sheet)
through ring (on tent body), and secure guyout cord
with stake. Repeat for opposite side
8. Stake remaining stake out loops
9. Secure remaining guyout cords to guyout loops fly sheet
and secure with stakes
10. Adjust final fly fit by adjusting webbing length at all
tension buckles
REV 092916