Philips 19HFL3233D/10 Service Manual page 13

5. Release all tapes that fit cables to the back side of the LCD
panel.
6. Remove all fixation screws of the sub frames on the sides
of the LCD panel.
7. Lift the sub frames, together with the mounted panels from
the LCD panel and put it aside.
8. Lift the LCD panel from the front bezel.
When defective, replace the whole unit.
4.3.7 LCD Panel 26"
1. Release the LVDS connector from the LCD panel.
2. Release the lamp connectors from the PSU.
3. Take out the speakers, as described earlier.
4. Remove the IR/LED board as described earlier.
5. Remove the PSU, as described earlier.
6. Remove the SSB, as described earlier.
7. Release all tapes that fit cables to the back side of the LCD
panel.
8. Remove all fixation screws of the sub frames and take out
these frames.
9. Remove all fixation screws of the clamps on the sides of
the LCD panel and take out these clamps.
10. Lift the LCD panel from the front bezel.
When defective, replace the whole unit.
4.4 Set Re-assembly
To re-assemble the whole set, execute all processes in reverse
order.
Notes:
• While re-assembling, make sure that all cables are placed
and connected in their original position. See
Figure 4-3.
• Pay special attention not to damage the EMC foams on the
SSB shields. Ensure that EMC foams are mounted
correctly.
Mechanical Instructions
Figure 4-1 to
TPM8.2E LA 4. EN 13
2011-Jun-01