Nomenclature And Functions; Handling Precautions - Toa IP-A1PC238 Instruction Manual

Ip ceiling speaker
Hide thumbs Also See for IP-A1PC238:
Table of Contents

Advertisement

5. NOMENCLATURE AND FUNCTIONS

[Front]
1. Control input terminals
Allows input of control signals from connected
external equipment to enable actions set in
the Event settings.
2. Functional ground terminal
If excessive noise is produced when the
speaker is connected to external equipment,
connect
this
terminal
equipment's functional ground terminal,
potentially minimizing the noise level.
Note
This terminal is not for protective ground.
3. Control output terminals
Allows control of external equipment in
synchronization with speaker operation.
4. LAN port
Connect to a PoE switching hub using a LAN
cable.
Tip
Amplifier rated output is 8 W.
5. LINK/ACT indicator (green)
Flashes when data is being sent or received
over a network.

6. HANDLING PRECAUTIONS

• Please apply the latest firmware version to this product. The latest version is available at the TOA
DATA Library (https://www.toa-products.com/international/).
• As this product is IP-based, a slight time lag between actual and broadcast may happen.
• Broadcast audio may sometimes break up due to packet loss or network failure.
• Periodic inspection and manual rebooting are needed to extend the product life.
This product may reboot automatically to keep the stable operation.
6
[Side]
4
1 2 3
5
to
the
external
6
6. Status indicator (orange)
Indicates the speaker's operating status.
Speaker Operation
System startup
Broadcast standby Continuously lit
Broadcasting
System mute*
Initialization or
firmware updating
* System mute is a state in which this
speaker is muted by the control from the
transmitting device.
7. Reset key
The speaker begins to restart when this key
is clicked.
Hold down this key until the Status indicator
(6) flashes slowly to initialize the speaker's
settings.
8. Safety wire attachment hole
Used as an attachment point for safety wire
to prevent the speaker from accidentally
falling.
See "INSTALLATION PRECAUTIONS" on
p. 7.
[Rear]
7 8
Status Indicator
Flashing twice
Continuously lit
Flashing quickly
Flashing slowly

Advertisement

Table of Contents
loading

Table of Contents