Fujitsu UTY-VBGX Instruction Manual page 152

Bacnet gateway for vrf system
Table of Contents

Advertisement

BACnet Gateway for VRF System
8.7 Diagnostic
Use this setting to check the current communication status of the gateway on both: BACnet and FGL.
Communication with the box, the BACnet side and the Fujitsu system can be check using the viewer available.
1. Hardware Test: Checks the current hardware status of the gateway to ensure that is not faulty.
2. Log: Enables the LOG Record Mode which starts loggin communications from all viewers and stores it in
a zip file. This file can be sent directly to the support team to check any unexpected behavior of the
gateway.
3. Commands: It sends specific commands to the gateway to perform general actions. It is for
maintenance purpose only.
INFO? Asks the gateway to identify itself and show basic information.
RESET! Resets the gateway. This is not a back to factory settings action.
Enable COMMS Enables communication between the gateway and the Configuration Tool
Disable COMMS Disanables communication between the gateway and the Configuration Tool
8.7.1 Console
Shows basic information about the gateway and communication between BACnet and VRF systems. This is for
Fujitsu internal maintenance purpose only.
8.7.2 BACnet Server Viewer
Shows specific information about the BACnet communication. This is for Fujitsu internal maintenance purpose only.
Figure 8.12 Diagnostic tool
Copyright© 2021 Fujitsu General Limited - All rights reserved
INSTRUCTION MANUAL r1.4.0 eng
152/159

Advertisement

Table of Contents
loading

Table of Contents