Skil PWRCORE HD6290A-00 Owner's Manual page 14

Function Selector and Torque-Adjustment Ring (Fig. 6)
Your tool is equipped with a function selector for various applications. Move the selector
depending on the requirements of your task.
Do not adjust the torque or switch functions when the tool is running.
CAUTION
Your tool also features 17 clutch settings for the screw-driving position . Output torque
will increase as the clutch ring is rotated from 1 to 17. When driving a screw, first try torque
position 1 and increase until the desired torque is reached.
The proper setting depends on the job and the type of bit, fastener, and material you will be
using. In general, use greater torque for larger screws. If the torque is too high, the screws
may be damaged or broken. For delicate operations, such as removing a partially stripped
screw, use a low torque setting.
The Drill setting will lock the clutch to permit (non-hammer) drilling or driving for heavy-
duty work.
The Hammer Drilling setting will lock the clutch to permit hammer drilling only.
NOTICE: Do not use the hammer drilling setting for drilling in wood, metal, ceramic, and
plastic to prevent the drill/screw bit from being damaged.
Fig. 6
17 1
LED Worklight (Fig. 7) Fig. 7
Your tool is equipped with an LED worklight,
located on the base of the tool, that illuminates
when the variable-speed trigger switch is
squeezed. This provides additional light on the
surface of the workpiece for operation in lower-
light areas.
The LED light will automatically turn on with a
slight squeeze on the variable-speed trigger
switch before the tool starts running, and will
turn off approximately 10 seconds after the
variable-speed trigger switch is released.
LED worklight
The LED light will rapidly flash when the tool
and/or battery pack becomes overloaded or too
hot, and the internal sensors will turn the tool
off. Rest the tool for a while or place the tool and battery pack separately under air flow to cool
them.
14