Troubleshooting - Silvercrest SDI 2800 D4 Operating Instructions Manual

Troubleshooting

PROBLEM
The appliance is
The plug is not connected.
not working. The
On/Off indicator
lamp 0 does
The appliance is damaged.
not light up.
There is no cooking vessel on the
respective induction field 1/3.
The pot/pan is not suitable for
The appliance
induction cookers.
does not start
cooking.
The child lock is activated
There is no vessel on the respec-
tive induction field 1/3 or the
" " appears
pot/pan is too small.
on one of the
displays t.
The pot/pan is not suitable for
induction cookers.
" " appears The temperature sensor under-
neath the induction field 1/3
on one of the
displays t.
is defective.
" " appears The appliance is being supplied
on one of the with excessively high voltage
displays t.
(> 275 V).
" " appears The appliance is not being
on one of the supplied with enough voltage
displays t.
(< 150 V).
" " appears The temperature sensor beneath
the induction field 1/3 is de-
on one of the
displays t.
fective or there is a short circuit.
" " appears
on one of the The electronics have overheated
displays t.
■ 16 │ GB │ IE │ NI │ CY
POSSIBLE CAUSE POSSIBLE SOLUTIONS
Connect the appliance to a mains
power socket.
Contact the Customer Service
department.
Place a suitable pot/pan on the
respective induction field 1/3.
Use a suitable pot (see the "Suitable
cookware" section).
r and
Hold down the
buttons for about 3 seconds.
Place a suitable pot/pan on the
respective induction field 1/3.
Disconnect the plug from the mains
power socket and contact the Cus-
tomer Service department. Enter the
error code.
Make sure that the appliance is
connected to a properly installed
mains power socket supplying
220–240 V ~ , 50/60 Hz.
Make sure that the appliance is
connected to a properly installed
mains power socket supplying
220–240 V ~ , 50/60 Hz.
Disconnect the plug from the mains
power socket and contact the Cus-
tomer Service department. Enter the
error code.
Check to see whether the fans on
the bottom of the appliance are
working correctly and whether they
can take in a sufficient volume of air.
z
SDI 2800 D4