Belt And Buckets - York M36 Manual

Belt and Buckets

23
install the buckets to the belt
At any point during the construction process
the buckets can be fastened to the belt. Use
the pre-punched holes in the belt to attach the
buckets (examples a and
so the head draws flush with the belt surface.
24
thread belt assembly into elevator
Remove the inspection cover door. (Do not do
this if winds exceed 20 mph!) From the top
of the elevator, thread a rope down the leg to
the point where the inspection door is located.
Fasten the rope to the assembled belt. Using a
come-along pull the belt through the inspection
opening to the top of the leg, wrap it over the
head pulley and thread it down the other leg.
i
IMPORTANT NOTE: Allow the belt to hang over
the head pulley for 24 hours. This will remove much
of the belt slack.
GLOBAL
2015-08-31
b). Tighten the nuts
INDUSTRIES, INC.
Assembly
a) Steel Bucket Installation
FLAT HEAD
BOLT
b) Plastic Bucket Installation
FLAT HEAD
BOLT
FLAT WASHER
83
FLANGE NUT
NUT
LOCK WASHER
10230004
M36 - M48 Bucket Elevator