Mitsubishi Electric CITY MULTI PEFY-P06NMAU-E4 Technical & Service Manual page 41

[ VIII Troubleshooting ]
To set the external static pressure with the switches on the control board
External static pressure
35 Pa
50 Pa
70 Pa
100 Pa
150 Pa
To set the external static pressure from the function selection screen on the remote controller (PAR-40MAAU)
Follow the instructions below and the instructions detailed in the remote controller manual for how to set the switches.
1. Set the function setting No. 32 (Switch setting/Function selection) to "2".
2. Set the function setting No. 8 and No. 10 to appropriate values, according to the external static pressure.
Selection
Switch setting
Function selection
External static pressure
35 Pa
50 Pa
70 Pa
100 Pa
150 Pa
6. 1s and 10ths digits
(1) SW11, SW12 (Rotary switch)
The use of an ME remote controller requires address setting.
Address settings must be made while the unit is stopped.
Factory setting
7. Connection No. setting
(1) SW14 (Rotary switch)
This switch is used when the unit connected to an R2 series of outdoor unit.
Factory setting
Note:
Changes to the dipswitches SW11, SW12, SW14, and SW15 must be made while the unit is stopped and the remote controller
is OFF.
HWE20150
SW21-1 SW21-2 SW21-5
OFF OFF
ON OFF
OFF ON
OFF OFF
ON OFF
Function
setting No.
Initial setting
No. 32
1 ○
2
Function setting No.
No. 8 No. 10
2 1
3 1
1 2
2 2
3 2
- 34 -
Initial setting
OFF
OFF ○
ON
ON
ON
Current setting
Current
Initial setting
setting
○
[Important]
Be sure to write down the set-
tings for all functions in the
"Current setting" row if any of
the initial settings has been
changed.
GB