Table of Contents
Advertisement
Cleaning and care
Refit the grease filters. When
inserting the grease filters, make sure
that the latch faces outwards.
If a grease filter is inadvertently fitted
upside down, insert a small
screwdriver blade into the slit to
disengage the clip.
Swing the panel closed until the
magnets hold it in place.
Resetting the grease filter operating
hours counter
After cleaning, the operating hours
counter needs to be reset.
While the fan is switched on, press
the grease filter control for approx.
3 seconds until only 1 is flashing.
The grease filter symbol goes out.
Change grease filters
Regular use and cleaning can cause the
filter surfaces to wear.
If you notice any damage, replace the
grease filters.
You can obtain grease filters from Miele
customer service (see end of these
operating instructions) or from your
Miele specialist dealer.
38
NoSmell active charcoal filters
With recirculation mode, two charcoal
filters must be fitted in addition to the
grease filters. These are designed to
absorb cooking odours.
Charcoal filters are available to order via
the Miele online shop (see the end of
this booklet for contact details) or
directly from Miele.
The part number of the charcoal filter
required is listed under "Technical data".
Fitting/Replacing the charcoal filters
Remove the panel and remove the
drip tray as previously described.
Take the charcoal filters out of their
packaging.
Insert the charcoal filters into the
deflector plate. Make sure the tabs
are facing up.
Refit the drip tray and the panel.
When to change the NoSmell active
charcoal filters
Replace the charcoal filters when they
no longer absorb kitchen odours
effectively, or at least every 6 months.
Advertisement
Table of Contents
