Advertisement
Available languages
Available languages
BASIC SHREDDING OPERATION
PAPER,
1
Continuous operation:
20 minutes maximum
NOTE: Shredder runs
briefly after each pass to
Plug in and put
clear entry. Continuous
disconnect power
operation beyond 20
minutes will trigger
40-minute cool down
period.
ADVANCED PRODUCT FEATURES
Turbo Jam Release™
powers through jams
BASIC PRODUCT MAINTENANCE
OILING SHREDDER
If not oiled, a machine may experience diminished
sheet capacity, intrusive noise when shredding and could
recommend you oil your shredder each time you empty
your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
TROUBLESHOOTING
Paper jam:
Door open: Make sure bin is pushed in
Overheat: Wait 40 minutes for motor to cool down
Paper jam:
1
2
Press and hold
If jam has not cleared,
press and hold Reverse
(R) for 1 second
LIMITED PRODUCT WARRANTY
defects in material and workmanship and provides service and support for 1 year from the date of
from defects in material and workmanship for 5 years from the date of purchase by the original
consumer. If any part is found to be defective during the warranty period, your sole and exclusive
warranty does not apply in cases of abuse, mishandling, failure to comply with product usage
standards, shredder operation using an improper power supply (other than listed on the label), or service under this warranty, please contact us or your dealer.
CARD or CD
2
3
into paper entry
and release
button
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
3
an acceptable amount and
refeed into paper entry
4
5
or
Hold card/CD at edge
cards rotate safety flap
into place
2
3
Press and hold Reverse
*Apply oil across entry
(R) 2-3 seconds
instructions below
6
7
When finished
shredding set to
entry and release
3
Advertisement
