Olympus U-TV0.63XB Instructions

The U-TV0.63XB is a camera adapter with B4-mount (2/3 inch bayonet mount lens), which allows an imaging device
such as a digital camera to be installed on a microscope for use in capturing wide-angle images.
Before disposing of this product, be sure to follow the regulations and rules of your local government.
1
System Chart
Camera with B4-mount of 2/3 in. or less
· TV camera
· Digital microscope camera
DP80 [2/3 in.]
* This product can be mounted on the straight photo tube of a UIS2 (UIS) trinocular tube (U-TTR-2, U-TR30-2, U-
TR30NIR, U-SWTR-3, U-SWETTR-5, U-SWETR, U-ETR-4, U-CTR30-2, U-TLU-1) or the side port of the IX83/73/53 ,
IX81/71/51microscope.
} If the camera uses a larger CCD than specified, the image may lack brightness in the peripheral areas or part of
image may be cut off.
} If the camera has high sensitivity or is not provided with auto light control, the monitored image may become
whitish. Should this happen, lower the light intensity level of the microscope.
2
Assembly
1
c
a
b
e
a
2
h
4
B4-Mount Camera Adapter
U-TV0.63XB
0.63X B4-mount camera adapter
When you attach/detach the camera, be sure to keep placing it
CAUTION
on the stable table or desk.
} The following procedure details with the case using the DP80
microscope digital camera.
} When the lens components get dirty, clean it by referring to the
instruction manual for the microscope.
1
Rotate the adapter mounting area
2
arrow direction to loose it sufficiently, and adjust it so that the positioning
d
groove
2
Fit the positioning pin
with the positioning groove
camera adapter toward the camera head. Then, while securing the
camera adapter
a
adapter temporarily.
f 3
3 3
Using the Allen screw driver provided with the microscope, tighten the
mounting screw
4
Using the Allen screwdriver provided with the microscope, loosen the
straight photo tube clamping screw
tube, and fit the mount dovetail
i
into the straight photo tube
g 5
} For convenient parfocality adjustment operation, set the B4-mount
camera adapter so that the LOCK screws face sideways.
5
Insert the clamping screw
Straight photo tube
U-TV0.63XB
b
comes roughly in the center of the notch
of the camera adapter U-TV0.63XB
e
b
with your hand, rotate the adapter mounting area
d
under the camera head in the arrow direction to fix the camera
of the camera head to fix it completely.
f
of the trinocular tube.
i
and tighten it firmly.
g
INSTRUCTIONS
UIS2 trinocular
tube *
a
under the camera head in the
c
.
of the camera head, and push the
of the UIS2 (UIS) trinocular
g
of the B4-mount camera adapter
h
d