Skil PWRCORE 12 DL629A-00 Owner's Manual page 14

Torque-Adjustment Ring (Fig. 6)
Your tool features 17+1 clutch settings. Output
torque will increase as the torque-adjustment
ring is rotated from 1 to 17. The drill "
position will lock the clutch to permit drilling
and driving for heavy-duty work.
CAUTION
When using the drill/driver for different driving
applications, increase or decrease the torque in
order to help prevent damaging screw heads,
threads, workpiece, etc.
The proper setting depends on the job and
the type of bit, fastener, and material you
will be using. In general, use greater torque
for larger screws. If the torque is too high, the screws may be damaged or broken. For
delicate operations, such as removing a partially stripped screw, use a low torque setting. For
operations such as drilling into hardwood, use a higher torque setting.
LED Worklight (Fig . 7)
Your tool is equipped with an LED worklight,
located on the base of the tool, that illuminates
when the variable-speed trigger switch is
squeezed. This provides additional light on the
surface of the workpiece for operation in lower-
light areas.
The LED light will automatically turn on with a
slight squeeze on the variable-speed trigger
switch before the tool starts running, and will
turn off approximately 10 seconds after the
variable-speed trigger switch is released.
The LED light will rapidly flash when the tool
and/or battery pack becomes overloaded or too
hot, and the internal sensors will turn the tool
off. Rest the tool for a while or place the tool
and battery pack separately under air flow to cool them.
The LED worklight will flash more slowly to indicate that the battery pack is at low-battery
capacity. Recharge the battery pack.
14
Do not adjust the torque
while the tool is running .
Fig . 6
"
Torque
Settings
Torque Indicator
Fig . 7
LED worklight
Torque-Adjustment Ring