Installation Of The Tuner Unit; External Dimensions - Sony SRP-X351P Operating Instructions Manual

Installation of The Tuner Unit

1
Turn off the power of this unit.
2
Remove the tuner cover.
3
Check the up and down sides of the tuner unit, and
insert it into the slot.
The upper slot corresponds to MIC1 and the lower slot
to MIC2. (Set the group and channel of the tuner unit
to same as wireless microphone's one.)
Tuner unit

External Dimensions

MIC1
ECHO/
AUX SEND
ØON øOFF
+10
+5
0
-5
-15
-25
MIC4
Insert it deeply into the compart-
ment.
Do not insert or remove the tuner
unit while the power is on. This
may be cause of noise or
malfunction of the connector.
Tuner cover
MIC2 MIC3 MIC4 ST1 ST2 ST3
ECHO RETURN
ØON øOFF
MUTING
RF/ RF/ SIGNAL SIGNAL SIGNAL SIGNAL SIGNAL
SIGNAL SIGNAL
+10 +10
A
+5 +5
0 0
B
-5 -5
C
-15 -15
-25 -25 D
PLAYER PLAYER/RECORDER
336
482
4
Fix the tuner cover.
After installation of the tuner unit, turn on the power
of the unit and turn on the power of the wireless
microphone to check it is receiving. While receiving,
the RF/SIGNAL indicator lights up. Note that the RF/
SIGNAL indicator will not light up when the setting
channel of the microphone is different from the setting
of the tuner unit, or when the microphone power is
consumed.
NOTICE
To prevent breakdown or injury, do not put your hand
inside of the slot except when you install or remove the
tuner unit.
CLIP PROTECTION EMG +45V
MASTER VOLUME
MIC GROUP
BASS TREBLE BALANCE
MIN MAX MIN MAX L R
Unit ; mm
9