Initial Configuration - D-Link DWC-2000 Quick Installation Manual

Powering on the Device
To connect the device to a power source, plug one end of the AC power cord into the AC power connector on
the back panel of the device. Plug the other end into an electrical outlet and switch ON the power switch.
Note: We recommend using a surge protector for the power connection.

Initial Configuration

The wireless controller software is preinstalled on the DWC-2000. When the device is powered on, it is ready
to be configured. It comes with a default factory configuration that allows you to connect to it, but you should
configure the controller for your specific network requirements.
Discovering the Wireless Controller
Using the Web UI
To use the Web UI, the workstation from which you are managing the device must initially be on the same
subnet as the device. You will also need a compatible browser:
Browser
Microsoft
Internet Explorer
Mozilla Firefox
Apple Safari
Google Chrome
To access the device's Web UI:
1. Connect your workstation to one of the ports labelled LAN (1-4).
2. Ensure your workstation is configured with a static IP address in the 192.168.10.0/24 subnet.
3. Launch your browser and enter the IP address for the LAN interface
(The default IP address is http://192.168.10.1), then press Enter.
4. Log into the wireless controller Web interface. The default login information is:
• Username: admin
• Password: admin
Minimum Version
9, 10
23
iOS: 6.1.3
Windows: 5.1.7
26