Specific Functions Of The Pid Model - Ascaso Steel User Manual

ascaso
light will come on
the reverse operation to obtain the
required water.
Remember: do not heat the milk to
over 75°C. Beyond this temperature
you will scald the milk and it will not
be suitable for cappuccino.
The espresso is released at 75-80°C.
The milk is textured and heated to
between 55-70°C. It is important
to maintain these temperatures for
serving. The cups should therefore
be warmed on the cup warmer. If this
is not possible, heat the cup with hot
water prior to use.
DUO models
3. Put a cup below the hot water
nozzle
16
4. Press the switch
light will turn on
reverse operation to obtain the
required water.
6.
Specific functions of the
PID model
The UNO PID and DUO PID models
have a control system consisting of
a screen(24) and two control buttons
25 26
1. Coffee temperature, shown on
screen. To change it, press the
button
25
the message PrG, indicating that
it is in temperature programming
mode. Press button
the temperature, press
increase it. After three seconds
without pressing a button, the
system will return to its initial
setting.
2. Temperature units, in °C or F.
3. Pre-infusion, selecting the pump
activation and stop time between
0 and 5 seconds.
4. Timer, showing the time taken
to make a coffee. This function
can be turned on or off in the
programming menu. If on,
38
MAN.38 V7 - MANUAL STEEL-STEEL PID 2022.indd 38 MAN.38 V7 - MANUAL STEEL-STEEL PID 2022.indd 38
23 . Carry out
.
, the pilot
14
. Carry out the
23
, the screen will display
to reduce
25
26 to
the screen shows the time
24
taken to make a coffee, not the
temperature.
5. In stand-by mode, selecting an
activation period from 0 (off),
0.5/1/2 hours.
6. Correction parameter between
water temperature and
measurement in the machine. This
enables the water temperature to
be adjusted according to room
temperature.
7. On models DUO PID, this allows
you to switch the steam system
on and off, as well as to select its
temperature.
Enter the programming menu to
change the values of parameters 2 to
7. The process is as follows:
1. With the machine on, press and
hold button while pressing
26
for 3 seconds. The screen
25
will show the words SET UP
24
alternately, indicating that the
programming menu has been
accessed.
2. Press button to scroll through
25
the different parameters that can
be modified. Once the required
parameter is reached, press
button to change its values.
26
3. To change the value of the
selected parameter, press buttons
and to reduce or increase
25 26
the values, respectively.
4. After three seconds without
pressing a button, the system
saves the data and returns to its
initial setting.
NB!
The PID system can be
reset in the following way: With the
machine on, press the button
three seconds. The screen
show the text PrS, indicating that the
factory settings have been reset.
26 for
24 will
01/06/2022 9:30:23 01/06/2022 9:30:23