Advertisement
Regulatory information North America - United States of America Federal Communications Commission (FCC) Compliancy
statement:
Responsible Party - U.S. contact information
Technicolor Connected Home LLC, 4855 Peachtree Industrial Blvd, Suite 200, Norcross, GA 30092-USA.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate
this equipment.
FCC Part 15B Supplier's Declaration of Conformity
The FCC Part 15B Supplier's Declaration of Conformity (SDoC) for your product is available at the following internet address:
www.technicolor.com/ch_regulatory
FCC radio frequency interference statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
RF exposure statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific
operating instructions for satisfying RF exposure compliance. To maintain compliance with FCC RF exposure compliance requirements,
please follow operation instruction as documented in the product documentation.
When the product is equipped with a wireless interface, then it becomes a mobile or fixed mounted modular transmitter and must have a
separation distance of at least 20 cm between the antenna and the body of the user or nearby persons. In practice, this means that the
user or nearby persons must have a distance of at least 20 cm from the product and must not lean on the product in case it is wall
mounted.
With a separation distance of 20 cm or more, the M(aximum) P(ermissible) E(xposure) limits are well above the potential this wireless
interface is capable to produce.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Restricted frequency bands
In case this product is equipped with a wireless transceiver operating in the 2.4 GHz band, it can only use channels 1 to 11 (2412 to
2462 MHz) on U.S.A. territory.
In case this product is equipped with a wireless transceiver operating in the 5 GHz band, it meets all the other requirements specified in
Part 15E, Section 15.407 of the FCC Rules.
The availability of some specific channels and/or operational frequency bands are country dependent and are firmware programmed at
the factory to match the intended destination. The firmware setting is not accessible by the end user.
Manufacturer:
Technicolor Connected Home USA LLC
4855 Peachtree Industrial Blvd, Suite 200
Norcross, GA 30092-USA
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Page 5 of 6
Advertisement
