Utilitech PLWK432WAR8 Manual page 4

ASSEMBLY INSTRUCTIONS
1. Separate the diffuser (C) from the fixture body (A)
by shifting it to one side and pulling it from assembly.
2. Separate the ballast cover (B) from the fixture
body (A) by squeezing it in at dimples and pulling it
from the assembly.
3. Locate the ceiling joists with a stud finder (not
included).
Hold fixture body (A) in place and mark the holes.
Drill 1/4 in. holes through ceiling boards for toggle bolts
(not included) if needed. Be sure the supply wires
can pass directly into the fixture body (A).
NOTE: When mounted, the mounting hardware must
secure the fixture solidly to the ceiling. Screws
(not included) must penetrate joists or toggle bolts
(not included) must be placed through the
ceiling boards.
4. Remove the knockouts nearest to the power
supply wires. Protect wires passing through hole
with snap bushing (not included).
5. Remove the 4 screw hole knockouts from fixture
body (A) and fasten the ends (D) with screws (AA).
1
A
C
2
3
4
5
Knockouts
4
B
A
D
AA