Siemens Water Technologies Series Manual page 25

WT.050.130.000.UA.IM.1108
ACUTEC™ 35 SYSTEM
b. Unplug the terminal connectors on the top and bottom of the receiver
module. Refer to Figure 3.1.
c. Remove the receiver module from the enclosure by pulling out the
plastic clip at the top of the module while removing the module from
the rail in the back of the enclosure.
d. Turn the receiver module over. There are four plastic tabs on the back
side of the unit. Gently spread the plastic tabs out and lift the back
panel off the receiver, being careful not to break the tabs.
e. Gently push up on the terminal connectors. This will allow the elec-
tronic assembly to be lifted out of the housing.
Figure 3.1 - Front and Back Views of Receiver Module
19