Table of Contents
Advertisement
1.1.6
SI M card
Chapter 1 • Vehicular installation
10
H67706 Revision B
The satellite terminal requires an Inmarsat SIM to be installed.
In order to install the SIM, unscrew the six M3 screws using a Torx 10 screwdriver
and carefully lift up the radome, as shown in
the torque value for this type of screw is 0.6–0.8 Nm.
Note: Before removing the radome please make sure the terminal is disconnected
from the power.
Insert the SIM (supplied by the dealer) into the SIM card holder with the metal
contacts facing down. You will hear a click once the SIM card is correctly inserted.
The SIM card will protrude slightly from the metal casing, as shown in
Carefully replace the radome and reinstall the screws with a torque setting of 0.6––
0.8 Nm.
Figure 3
Figure 3. Removing the radome
Figure 4. Installing the SIM card
on page 10. Please note that
Figure 4.
SIM
Advertisement
Table of Contents
