Others; Troubleshooting - JVC VR-N900U Startup Manual

Others

Troubleshooting

Problem
Power cannot be turned on.
Camera is not automatically detected.
Unable to operate the system by pressing the
[REC] or [PLAY] button.
No images are recorded with recording control
mode.
Unable to play back sound.
Solutions to warning indicator light up
Error message
WARNING: HDD 0 (1)
OVERHEATED!
ENCODER ERROR(format)
ENCODER ERROR (xxx)
FAN STOP
E-26
Check that the power cable has been plugged in correctly.
Check that the power switch on the rear panel is switched on.
Follow the instructions in the camera's user manual and check the DHCP
settings.
Check that operation lock is not engaged.
Check the settings in the [Camera Record Setting].
Check that the scheduler is set to online.
Check that the camera is in recording control mode.
Check that audio for the camera device is set to [Enable] in the [Camera Record
Setting] window.
Possible cause and solution
The HDD seems to be no longer serviceable.
Replacement is recommended.
Consult to your nearest JVC dealer.
Check the temperature of the operating environment.
Check that the fan unit operates properly.
If the temperature of the operating environment is appropriate, consult to
your nearest JVC dealer.
Abnormality with the input signal.
Check the entered image signal.
Other abnormality.
Consult to your nearest JVC dealer.
Fan abnormality. Check that the fan is rotating.
CAUTION
Because it will cause the breakdown, please discontinue operating when
the fan does not rotate.
Consult to your nearest JVC dealer.
Solution