Power On With Two Probe Port; Disconnecting A Probe From The Two Probe Port - GE LOGIQ A100 Technical Publication

Power ON with Two Probe Port

To switch on power Press the 'I' (ON) position of the
power on switch (for further details refer illustration 5 on
page 20.
Â
LED
Â
1
Port 1 is selected as the default active port on power ON.
The corresponding LED glows.
default power
on port

Disconnecting a Probe from the Two Probe Port

Probes can be disconnected from the Two Probe Port
module irrespective of whether the system is ON or OFF.
To disconnect a probe move the probe connector lock
counter–clock wise through ninety degrees.
probe
Pull Probe Pull the probe connector straight out of the probe port.
Properly clean the probe and place in a secure place.
Store Probe
Probes can be disconnected from the Two Probe Port
irrespective of whether the probe is active or inactive.
Removal of the inactive probe has not impact on the
Hints
active scan.
t
α 100 User Manual
LOGIQ
2211157–100 Rev 0
Two Probe Port
95