Adjusting The Engine Idling Speed - Yamaha RAPTOR 700R Owner's Manual

1
1. Tailpipe
2. Spark arrester
4. Install the gasket, tailpipe, and retainer and
align the bolt holes.
5. Install the bolts and tighten them to the spec-
ified torque.
Tightening torque:
Retainer bolt:
10 N·m (1.0 kgf·m, 7.4 lb·ft)
6. Install the tailpipe cover and align the bolt
holes.
7. Install the bolts and tighten them to the spec-
ified torque.
EBU26813

Adjusting the engine idling speed

The engine idling speed must be checked and, if
necessary, adjusted as follows at the intervals
specified in the periodic maintenance chart.
2
TIP
A diagnostic tachometer is needed to make this
adjustment.
9-27
Tightening torque:
Tailpipe cover bolt:
8 N·m (0.8 kgf·m, 5.9 lb·ft)
1. Start the engine and warm it up.
2. Attach the tachometer to the spark plug lead.
3. Check the engine idling speed and, if neces-
sary, adjust it to specification by turning the
idle adjusting screw. To increase the engine
idling speed, turn the idle adjusting screw in
direction (a), and to decrease it, turn the
screw in direction (b).
9