Alarm And Sleep Operation - Sharp DK-CL5P Operation Manual

DK-CL5P
Listening to the radio (continued)
Note:
The batteries system protects the programmed stations should
there be a power failure or the AC/DC adaptor becomes
disconnected. If the backup batteries are drain off, the
programmed stations will be erased.
■ To recall a programmed station
Press PRESET/TRACK (
repeatedly or PRESET/FOLDER (
repeadtedly to select the desired programmed station.
22
or ) button on main unit
or ) on remote control
s r

Alarm and sleep operation

■ Alarm
The unit turns on and play desired source (iPod, iPhone or
TUNER) or Buzzer sound for 1 hour alarm cycle.
Before setting the alarm:
1 Check that the clock is set to the correct time. (refer page 15)
If it is not set, you cannot use the alarm function.
2 For iPod or iPhone playback: Insert iPod or iPhone to the
unit. (refer page 17)
3 For TUNER: Set preset memory. (refer page 21)
Setting the alarms
In this example, the setting is for ALARM 1. The same method
is used to set for ALARM 2.
1
In standby mode, press and hold the ALARM 1 button
until the alarm time blinking.
2
Press the ( or ) button to adjust the hour and
press the ALARM 1 button.
PM
Press the ( or ) button once to advance the time by 1
hour. Hold it down to advance continuously. "AM" or "PM"
indicator will interchange after each 12 hour cyclic.