Hookup Diagrams - Mackie THUMP GO Quick Start Manual

Hookup Diagrams

Thump GO loudspeakers are the perfect tool for singer-songwriters touring the local coffee shops.
Bring your favorite axe and mic, Thump GO loudspeakers and cables and power cords.
In this example, a Mackie EM-89D dynamic microphone is connected to the channel 1 input of a Thump GO,
used for monitoring purposes. The gain knob should be set to mic and the mic/line switch engaged (mic).
Now grab your axe and plug it directly into the channel 2 input. Or if you use effects, connect the guitar to the effects
input and another cable from the effects output to the channel 2 input. The gain knob should be set to line and the mic/line
switch disengaged (line).
Another Thump GO loudspeaker will be used for the main PA. Simply connect a cable from the Thump GO monitor's
THRU jack to the Thump GO PA's channel 1 input.
For the output, you will want to set a voicing mode, described in detail on page 10-11. For this type of setup, 'Music'
works well for the main Thump GO. Select the 'Monitor' mode for the Thump GO monitor.
Singer-Songwriter Setup
5
Owner's Manual