Memory Transmission; If The Memory Becomes Full - Sharp UX-A255 Operation Manual

Sending a Fax From Memory
6
When you are ready to begin transmission, press
A Transaction Report is automatically printed out after Broadcasting is
completed. Check the "Note" column of the report to see if any of the
locations are marked "Busy" or have a communication error code. If so,
send the document to those locations again.

Memory transmission

You can also send a fax through memory when sending to a single location.
This is convenient when sending to locations where the line is often busy, as it
saves you from waiting to pick up the original document and frees the feeder
for other operations.
To send a fax through memory, load the document, press
dial using one of the following methods:
Press the number keys to enter the fax number and then press
Press
Press

If the memory becomes full...

If the memory becomes full while the document is being scanned, MEMORY
IS FULL and SEE MANUAL will alternately appear in the display.
START/MEMORY
Press
to that point in memory. The remaining pages will be ejected from the
feeder. After transmission, the memory will be cleared and you can transmit
the remaining pages. You will also need to transmit the page which was
being scanned when the memory filled up.
STOP
Press
64
repeatedly to select an auto-dial number and press
once to select the last number dialed and press
if you want to transmit the pages which have been stored up
if you want to cancel the entire transmission.
START/MEMORY
.
START/MEMORY
, and then
START/MEMORY
START/MEMORY
START/MEMORY
.
.
.