Shark UV610 Owner's Manual page 4

CHARGING THE CORDLESS SWEEPER
1. Connect the charger plug to the charging jack or hole on the back of the
sweeper. Plug the the charging adapter into the wall outlet. (120V~,60Hz.) Use only
TechWorld Charger AD-0920-UL, rated output DC 9V,200mA. (Fig. 9)
2. This cordless sweeper is powered by Ni-Cd batteries. Before first use,
they must be charged for a minimum of 16 hours.
3. Once the batteries are fully charged, the cordless sweeper will run for
approximately 35 to 45 minutes before recharging is required.
4. When recharging the unit, the "On/Off" switch must be in the "OFF" position.
5. To recharge, repeat step #1 above. Charging times will vary depending upon
the amount of usage between charging cycles.
6. The charging light indicator on the top of the sweeper will illuminate
to indicate that the sweeper is properly charging.
NOTE:
Peak performance may only be realized after the unit
has been charged and discharged two (2) or three (3)
times.
IMPORTANT:
To maintain peak performance of your cordless
sweeper, it is recommended that the unit be fully
discharged, then completely re-charged at least
once a month.
CAUTION
• Use only with the battery pack supplied with the unit.
• Do not attempt to remove the battery pack from the unit to charge it.
• Never attempt to throw the battery pack or unit into a fire or incinerate
it.
• Do not attempt to remove or damage the battery casing.
• Battery must be recycled or disposed of properly at the end of it's
service life.
Fig. 9
6
Changing the Rotating Brush & Gear Box
WARNING:
Use caution when changing the rotating brush and gear box
so that the unit does not turn ON when pressing down on the
sweeper power head.
1. Remove the extension tube handle from the sweeper power head.
2. Turn sweeper power head upside down being careful Not to accidentally turn the
unit ON.
3. Remove the transparent brush cover. (Fig. 10) (Refer to page 5 for detailed
instructions.)
4. Push in on the locking tab of the gear box and lift gear box to remove. (Fig. 11 &
Fig. 12)
5. Lift the brush bar end cap up from the slot. (Fig. 13)
6. Pull the brush bar out from the bushing and slip off the belt to remove the
brush bar. (Fig. 14)
7. Insert the new brush bar by first inserting the brush bar into the bushing on the
end opposite the driver belt. (Fig. 14)
8. Slip the belt over the brush bar cap.
9. Insert the brush bar into the slot. (Fig. 13)
10. Insert the gear box tabs into the tab slots and push down until it clicks into place.
Gear box
Gear box
tabs
Fig. 10
Fig. 13
Lift
Locking
tab
Fig. 11
Fig. 12
Fig. 14
7