Seiko KINETIC 9T82 Instructions Manual

Seiko kinetic watch cal.9t82 instructions manual

Advertisement

Cal. 9T82
INSTRUCTIONS
BEDIENUNGSANLEITUNG
INSTRUCTIONS
ISTRUZIONI
INSTRUCCIONES
INSTRUÇÕES
用法説明
(P.
3)
(S. 15)
(P. 28)
(P. 40)
(P. 53)
(P. 65)
(77 頁)

Advertisement

Table of Contents
loading

Summary of Contents for Seiko KINETIC 9T82

  • Page 1 Cal. 9T82 INSTRUCTIONS BEDIENUNGSANLEITUNG INSTRUCTIONS ISTRUZIONI INSTRUCCIONES INSTRUÇÕES 用法説明 (S. 15) (P. 28) (P. 40) (P. 53) (P. 65) (77 頁)
  • Page 2 Você pode sentir-se orgulhoso de ter adquirido um SEIKO KINETIC Cal. 9T82. Para obter ® dele os resultados máximos, solicitamos-lhe que, antes de usar o seu SEIKO KINETIC , leia atentamente as instruções contidas neste opúsculo. E guarde este manual para referências...
  • Page 3: Table Of Contents

    HOW TO CHARGE AND START THE WATCH ... POWER RESERVE IN YOUR SEIKO KINETIC WATCH ... REMARKS ON THE KINETIC E.S.U..ENERGY DEPLETION FOREWARNING FUNCTION ... HOW TO OPERATE THE SCREW LOCK TYPE CROWN ... TIME/CALENDAR SETTING ... STOPWATCH ...
  • Page 4: How To Charge And Start The Watch

    Swing the watch from side to side approximately 200 times. * Swing rhythmically at a rate of twice a second. * 200 swings will start the watch and the second hand will move at one-second intervals. Swing the watch approximately 200 times further to reserve one day of power.
  • Page 5: Power Reserve In Your Seiko Kinetic Watch

    Wearing the watch continuously for 12 hours will accumulate approximately four additional days of power reserve. If you wear the watch every day for 12 hours a day over a week, for example, the watch will be fully charged. Full charge When the watch is fully charged, the watch will keep operating for approximately 1 month.
  • Page 6: Remarks On The Kinetic E.s.u

    12 hours. * If the second hand starts moving at two-second intervals while the stopwatch is in use, the watch will run down in approximately 1 to 2 hours assuming the stopwatch remains in use.
  • Page 7: How To Operate The Screw Lock Type Crown

    HOW TO OPERATE THE SCREW LOCK TYPE CROWN To unscrew the crown: Turn the crown counterclockwise. (Then, pull it out for time/calendar setting) Screwed-in position To screw in the crown: With the crown at the normal position, turn it clockwise while pressing it. Unscrewed position...
  • Page 8: Time/Calendar Setting

    TIME/CALENDAR SETTING Hour hand a. Screwed-in position b. Unscrewed position First click d. Second click CROWN Second hand Unscrew and pull out to the first click. Turn counterclockwise until the pre- vious day’s date appears. Minute hand Pull out to the second click when the Date second hand is at the 12 o’clock posi- tion.
  • Page 9: Stopwatch

    STOPWATCH The stopwatch can measure up to 12 hours, 6 minutes and 12.2 seconds in 1/10 second increments. The measured time is indicated by small STOPWATCH hands that move independently of the hands for time indication. TIPS ON READING THE HANDS The STOPWATCH minute hand turns a full circle in 30 minutes.
  • Page 10 Ex. ) 1 hour 55 minutes 50 seconds 9 STOPWATCH second hand reading: The STOPWATCH second hand almost points to “51” but should be read as “50”, as the STOPWATCH 1/10 second hand indicates “9”. STOPWATCH 1/10 second hand STOPWATCH minute hand reading: The STOPWATCH minute hand almost points to “26”...
  • Page 11 Before using the stopwatch, be sure to reset the STOPWATCH hands to “0” position. 1) Check that the watch is operating normally. * If the watch has stopped completely or if the second hand is moving at two-second intervals, charge the watch sufficiently. (See “HOW TO CHARGE AND START THE WATCH”) If the STOPWATCH hands are moving, press button B to stop the measurement and then press button A to reset the STOPWATCH hands to “0”...
  • Page 12: Notes For Using The Watch

    Wear the watch daily for at least 10 hours. Even if the watch is worn on your arm, it will not be charged while your arm is not in motion. POWER RESERVE IN YOUR SEIKO KINETIC WATCH...
  • Page 13 24 hours. Turn the hands past the 12 o’clock marker to determine whether the watch is set for the A.M. or P.M. period. If the date changes, the time is set for the A.M. period. If the date does not change, the time is set for the P.M.
  • Page 14: Specifications

    While the stopwatch is measuring, pressing button A will not reset the stopwatch. Do not press buttons A and B at the same time, nor press one of the two buttons while keeping the other pressed. Otherwise, a malfunction will result. SPECIFICATIONS Frequency of crystal oscillator ...

Table of Contents