IOGear GCS1212TAA4 User Manual page 21

Single/dual view secure kvm switch. 2/4/8-port usb dvi/hdmi/displayport

Hide thumbs Also See for GCS1212TAA4:

Table of Contents

Hardware Setup

Connect the cable on the RPS to the switch RPS port. (Optional)

Note:

Connect the RPS before the IOGEAR Secure KVM is powered on

Any connection of RPS after the IOGEAR Secure KVM is powered on will not be

detected by the switch

Connect the female end of the power cord into the IOGEAR Secure KVM Switch's power socket.

Then, connect the male end of the power cord into an AC power source.

Power on the IOGEAR Secure KVM Switch and check if the LEDs light up. IOGEAR Secure KVM

Switch will begin KVM self-test momentarily.

Note:

IOGEAR Secure KVM Switch performs a security self-test at power-on and at each

power cycle. Front panel LEDs will indicate the self-test status and test result. Please

refer to the Operation section and the LED Display section for visual identification

details.

Table of Contents