Soundstream VRCPAA-7DRM Owner's Manual page 4

2. Accessories & Installation
Installation
Dashboard
Bracket
Installation
1.Put the 2 brackets to the left and right
side of the headunit.
2.Use screws to fix the brackets to the
unit.
3.Install the body chassis into the
dashboard via the 2 brackets.
4.Install the trim ring to the body
chassis.
Note:
1. Make sure the ignition is turned off,
and disconnect the cable from the
vehicle batteryʼs negative (-)
terminal.
You never want electricity running
when you install this 2-DIN car
receiver.
2. Before installation, disconnect the
wire harness and the antenna.
3. Attach the brackets on the both
sides of the car receiver with
screws as shown as the installation
drawing. Please buy from your
dealer according to the drilling of
holes size.
Bracket
4
4. Consult with your nearest dealer if
installation requires the drilling of
holes or other modification of the
vehicle.
5. Install the car receiver in the dashboard.
6. Connect the wire harness & antenna
to the car receiver being carefully not
to pinch any wires or cables.
7. Install the plastic outer trim ring onto
the car receiver.
8. Reconnect the battery and run through
all of the options on this car recei ar
you intend to install it in. Please
choose the correct installation method
according to the actual situation of
your car. Always contact the car dealer
or manufacturer if you have any
questions.
Parking wire
Note: The parking wire is connected with
brake signal; for safety, the programs can
be seen on the monitor after braking the
car..
Note: To watch video the parking wire
should be connected to brake signal.
Parking brake lead
Brown wire
2A
Connecting the reversing line to taillight on
the car
Reverse driving light
Car frame
Pink wire
Rear view video camera lead
After connecting, when you start up the
reverse gear, the unit will receive the
picture from car rear view camera.
12V
battery
Brake light Car frame
+
-
12V
Battery
Car frame
P
R
N
D
2
L
Gearbox